2 Pin Strip to Strip Clip Joint for IP67 Single Colour 8mm (Inner) 10mm (Outer) SMD & COB Strip Pack of 5

When you require a reliable, IP67 rated, compact connector to link LED strips together with a seamless joint, this mini strip to strip Clip Joint Connector from our professional range of discrete connectors is the ideal solution. The connector is suitable for both single colour, IP67 rated COB and SMD type LED strips with an inner strip width of 8mm and an outer coated width of 10mm. The outer dimensions of the connector are 15mm Wide x 8mm Deep so they can be incorporated into a profile enabling you to hide the connector inside the profile if required.

The connectors are rated at Max load 3V - 24V DC 5A and are clamped into place on the LED Strip by sliding the two transparent parts of the connector over each LED Strip and then joining the two together, gripping the connector firmly at the two clip points and closing the connector around the LED Strip, take care to slide the LED strip into the connector body all the way so that the pins line up with the cut points on the LED Strip. You will then squeeze the connector closed firmly until it clicks into place to seal the connection.

Note: The connector will pierce the LED strip ensuring a secure grip onto the tape so it will not slide off, the electrical connection is also very secure so there is minimal voltage loss over the joint. Once the connector has been clamped onto the strip, it is not recommended to remove it as damage to the LED Strip will occur. If it is necessary to remove the connector, carefully insert a small flat headed screwdriver under the side clips to release them, care must be taken to avoid injury as it is easy to slip with the screwdriver. Once the connector has been used it is not advisable to use it again.

For more information on this or any of our connector range, please contact our technical sales team by phone, email or via live chat and WhatsApp on our website.