Solderless Single Connector

Make solderless connections to uncoated LED strip with these single connectors. Choose the strip size and connection type to suit your installation.

• 10mm RGB: a 4-contact clip with colour-coded, pre-tinned 150mm tails.
• 12mm RGBW: a 5-contact clip with colour-coded, pre-tinned 150mm tails, or a direct strip-to-strip joining connector.
• White clip housings for dry, indoor IP20 installations.
• Supplied individually. Only the listed size and connection combinations are available.

Fitting and compatibility

Use with the matching strip width and copper-pad layout. These connectors are intended for uncoated IP20 strip and are not designed to pierce silicone coatings or maintain an IP67 rating.

1. Disconnect the power and cut the strip only at its marked cutting points.
2. Open the connector cover and expose the copper contact pads. Carefully remove any clear lacquer covering the pads where necessary.
3. Insert the strip so that its pads line up with the connector contacts, checking polarity and channel order.
4. Close the cover firmly until its locking tabs latch. For the direct join, fit the second strip in the opposite side; for a tailed clip, connect the colour-coded leads to the appropriate wiring.
5. Check the connection before completing the installation.

Do not use a connector to exceed the strip manufacturer's permitted run length. For the direct join, the original guidance specifies joined lengths below 5m.